Bare Frame Restoration
Grab the Frame Coater Kit or Large Frame Coater Kit today!
Clear Coated El Camino Wheels
“I purchased the diamond clear to use on my wheels on a 77 El Camino. The wheels were chemically stripped and the outer wheel was sanded and polished to an almost mirror shine (as good as my patience would allow), the center of the wheels were base coat and clear coat with standard two stage paint system. I reduced the diamond clear the full 30% for spraying. The clear was wet sanded after 2 days with 2000 grit and then compounded with a wool disc at 1500 rpm. In the end the wheels turned out very good!” -Tim G
BlackTop Chassis Paint
BlackTop is a permanent, moisture-cured, UV stable coating primarily used for topcoating surfaces previously sealed with RustSeal or any other paint/primer application. BlackTop is a high performance protective coating specifically formulated to withstand dulling and fading caused by prolonged sunlight exposure.
Motor Coater on 69 Camaro Engine
“Redid the engine compartment, (without removing the engine) on my 1969 Camaro using Motor Coater. The gloss is amazing! It has never looked better in the 25 years I’ve owned it. -Mike D
Engine Coater with Motor Coater Engine Paint
“I sprayed 3 coats of KBS Gloss Black Motor Coater allowing each coat to fully cure and scuffing with a red scotch brite pad between coats to get a fairly smooth surface. Finally, I sprayed 3 coats of KBS Diamond Clear. I’m super happy with the results!” -Jamie P
XTC Jet Black Before and After Pictures
“Restoring a 1929 Chevrolet 4 Door International with a first Generation 194 cu 6 Cylinder Engine. I blasted the Exhaust manifold, then cleaned and prepped it to remove any debris and oil. primed following instructions, 2 coats. Then top coated with the XTC 2 Coats, then Cured it per instructions. It came out better then expected. I am really happy!” -Jerry A.
XTC: https://www.kbs-coatings.com/XTC.html
XTC Primer: https://www.kbs-coatings.com/XTC-Primer.html
XTC Now Available In Clear
XTC is now available in Clear which adds gloss and clarity to your finish! XTC is a high temperature/heat resistant coating formulated specifically to protect metal surfaces operating at temperatures from 500° F to 1500° F. With proper preparation, XTC provides outstanding adhesion, film integrity, weathering, and thermal shock-resistance throughout this entire temperature range, and is guaranteed not to burn off!
XTC Jet Black on Headers
XTC is a high temperature/heat resistant coating formulated specifically to protect metal surfaces operating at temperatures from 500° F to 1500° F. With proper preparation, XTC provides outstanding adhesion, film integrity, weathering, and thermal shock-resistance throughout this entire temperature range, and is guaranteed not to burn off! Available in 10 great colors.