Seal Your Lawnmower Deck To Prevent Grass From Sticking

Remember Your Lawnmowers!

As you are pulling out your lawnmowers and getting them ready for spring, remember that RustSeal on the underside of the deck will prevent rust and the slick surface provided by the RustSeal will prevent grass from sticking to the deck and clogging up the discharge.

Pick a glossy finish like Gloss Black RustSeal for the slickest surface and watch the grass fall right off and not clog up your mower.

+Go HERE to order the System Sampler which contains everything you need to clean, prep, & apply two coats of RustSeal on up to a 12.5 square foot area.

Rust Prevention | Safety Blue RustSeal Has Arrived

Safety Blue RustSeal

MACHINERY RUST PREVENTION IN SAFETY BLUE

KBS RustSeal is a superior one part, completely non-porous, ready-to-use paint.

KBS RustSeal is a high-solid content, rust preventive coating, that is actually strengthened by exposure to moisture.

KBS RustSeal is impervious to road salts and most every chemical.

KBS RustSeal flows out to a beautiful, rock-hard, tough coating that is tough to chip or scratch. These exceptional properties make RustSeal specifically formulated to prevent corrosion and stop rust.

KBS RustSeal completely seals metal surfaces, blocking all the pores and preventing penetration of moisture, oxygen, and water vapor. Try some today…you’ll be amazed!

Features:

• CAN BE APPLIED DIRECTLY OVER RUST!

• SEALS & ENCAPSULATES RUST AND POROUS SURFACES

• APPLY BY BRUSH, ROLLER, OR SPRAY.

• SUPER STRONG AND FLEXIBLE – HAMMER TOUGH!

• HIGHLY RESISTANT TO MOST CHEMICALS

• MODERATE UV STABILITY, UNLIKE OTHERS WHICH CAN CHALK WITHIN WEEKS

• COMPATIBLE WITH ALL PAINT SYSTEMS

• COMPLETELY NON-POROUS

+CHECK OUT SAFETY BLUE RUSTSEAL

Apply RustSeal In Thin Coats | Tip Of The Month

RustSeal

APPLY RUSTSEAL IN THIN COATS

Remember that RustSeal should be applied in THIN coats. Applying too heavily, will cause running and/or sagging on vertical surfaces, and possible bubbling on horizontal surfaces. As RustSeal cures, it releases a small amount of carbon dioxide. If allowed to “puddle”, the top of the RustSeal directly exposed to the ambient humidity in the air (the actual catalyst for RustSeal) will begin to "skin" over. This "skinning over" is much like that of chocolate pudding and blocks the release of the afore mentioned carbon dioxide causing bubbles. By applying thin coats, this film cures through and through all at once.

MORE TIPS & TRICKS

RustSeal Fix-It Guide: This guide helps you quickly identify the causes of and the recommended solutions for the most common issues that could occur for RustSeal.

Note: We would love for you to share your tips with us.
Email us (suggestions@kbs-coatings.com) with your tips.

Customer Photos: Cat Yellow RustSeal

CAT YELLOW RUSTSEAL APPLIED TO MACHINERY

One of our customers uses Cat Yellow RustSeal as a safety yellow paint on the machinery at thier shop. They really like the RustSeal and sent us some pictures to show us the Cat Yellow RustSeal in action.

RustSeal - Paint Over Rust - Stop Rust

RustSeal - Paint Over Rust - Stop Rust

RustSeal - Paint Over Rust - Stop Rust

FEATURES OF RUSTSEAL – THE BEST STOP RUST PAINT

  • CAN BE APPLIED DIRECTLY OVER RUST!
  • SEALS & ENCAPSULATES RUST AND POROUS SURFACES
  • APPLY BY BRUSH, ROLLER, OR SPRAY.
  • SUPER STRONG AND FLEXIBLE – HAMMER TOUGH!
  • HIGHLY RESISTANT TO MOST CHEMICALS
  • MODERATE UV STABILITY, UNLIKE OTHERS WHICH CAN CHALK WITHIN WEEKS
  • COMPATIBLE WITH ALL PAINT SYSTEMS
  • ALL COLORS ARE COMPLETELY NON-POROUS

MORE INFORMATION AND DIRECTIONS ON RUSTSEAL

At KBS Coatings, we believe that offering the best Rust Preventive products is simply not enough. We alse believe in offering the best world-class customer support for using and applying all of our superior Rust Preventive products.

+Click Here for the KBS 3 Step System featuring KBS RustSeal

+Click Here for KBS RustSeal Complete Directions

+Click Here for the KBS RustSeal Flow Chart

+Click Here for KBS RustSeal Instructional Videos

+Click Here for KBS RustSeal on the KBS Suppot Forum

+Click Here for How To’s showing the application of KBS RustSeal

+Click Here for the KBS RustSeal Fix-It Guide

+Click Here for the KBS HelpDesk featuring Questions & Answers on KBS RustSeal

Tip Of The Month: Patch Rusted Hole

A TIP FOR REPAIRING RUSTED OUT PINHOLES:

Put a piece of tape behind the larger pinholes, then paint with 2 coats of RustSeal. When the RustSeal dries, pull the tape off and coat the the back side with RustSeal as well.

RustSeal - Paint Over Rust - Stop Rust

Note: We would love for you to share your tips with us. Email us (suggestions@kbs-coatings.com) with your tips.

RustSeal Featured in Street Rodder Magazine

“We used a product called RustSeal from KBS Coatings because we’ve found it to be perfect for painting the chassis of cars that are driven since it requires a minimum of preparation and it’s tough as nails so it resists chipping. For those without the ability to spray paint, most KBS products can be brushed and flow out without any brush marks.”

See what else the May 2011 Street Rodder Magazine had to say about KBS Coatings.


KBS Coatings - Street Rodder Magazine - May 2011

+Cover

KBS Coatings - Camaro Performers
+Page 1
KBS Coatings - Camaro Performers

+Page 2


KBS Coatings - Camaro Performers

+Page 3

KBS Coatings - Camaro Performers

+Page 4

Click Here for a Printer Friendly Version

You can also download the Entire Article in pdf format.
+CLICK HERE


RustSeal – Comes in Cat Yellow – Stop Rust Paint

ANNOUNCING … RUSTSEAL CAT YELLOW

Our Newest Completely Non-Porous Rust Preventive Paint

Motor Coater

Cat Yellow RustSeal is a full spec industrial yellow with micronized corrosion barrier pigments in a color well recognized on any work site as Cat Yellow. Heavy vehicle maintenance will never be the same!

KBS RustSeal is a superior one part, ready-to-use, high-solids content, rust preventive coating, that is actually hardened by exposure to moisture. It is impervious to road salts and most every chemical. RustSeal flows out to a beautiful, rock-hard, tough ceramic-like coating that is tough to chip or scratch, and will not crack or peel. Get some for your project today!

+FOR MORE INFORMATION OR TO ORDER

INTERNATROLET on V8S10.org says..

“Just thought I’d share. I can’t say enough good things about this stuff. If you need to paint a rusty frame or underbody or tank, this is what you want. I have used it several times with ZERO failures.

I have tried that Other Stuff and it’s good but not like this. The Other Stuff has a good high temp engine paint but for rust converter, KBS!”

Click here for the entire thread: http://www.v8s10.org/forum/viewtopic.php?f=26&t=23975

You can read what others are saying about stopping rust with KBS Coatings: http://www.kbs-coatings.com/customer-feedback.html

Ray W. says about RustSeal (Paint Over Rust)..

others - Stop Rust
+click for larger image

others - Stop Rust
+click for larger image

others - Stop Rust
+click for larger image

"Yes I did have the chance to use your rust seal! And I have to admit it is a bit better than the other two leading sellers. It was a hot day and humid too, since I’m in texas, and it went on nice but didn’t tack up for over an hour. But within two hours it was a really nice finish and really secured the little rust area’s very nicely!

I will be ordering another gallon within the next month or so when I go to finish the floors on my camaro. I have attached a photo or two for you.

Great product! Best yet!"

Click HERE for more Customer Photos using KBS Coatings.